GROUND DRIVE & TINE SYSTEMS
5-14
Toro 30” Aerator Service Manual
5
9. Tighten the front mounting bolts and the transmis-
sion adjustment plate bolts on both sides of the unit
tight, then loosen them one turn.
10. Turn the adjustment bolt to move the transmission
adjustment plates and hydros (Fig. 219).
Fig. 218 outside connect link transaxle
8. Install the transmission chain. Ensure that the cover
plate and spring clip are to the OUTSIDE of the
machine. Install the spring clip so the opening is
away from forward direction of rotation (Fig. 218).
Fig. 217 idler sprocket
7. Place the idler sprocket on the tine chain. Adjust
idler position to allow a maximum of 3/8” of chain
movement. Torque nut to 50 ft-lbs. (69 Nm) (Fig.
217).
Fig. 219 trans adj plate
To Next Page
Loading...
