Toro 23518 - Lubricate Grease Fittings

SPECIFICATIONS & MAINTENANCE
2-7
Toro 30” Aerator Service Manual
2
Lubricate Grease Fittings
Note: See chart for service intervals.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Lubricate ttings with NGLI grade #2 multi-purpose
gun grease.
Refer to the following chart for tting locations and
lubrication schedule.
Lubrication Chart
Fitting
Locations
Initial
Pumps
Number
of Places
Service
Interval
A. Front Caster
Pivots
*0 2 Yearly
B. Jackshaft
Bearings
1 8 25 hours
C. Wheel
Bearings
1 2 25 hours
D. Tine Shaft
Bearings
1 4 25 hours
E. Tine
Assembly Idlers
1 2 25 hours
F. Control
Pivots
1 4 50 hours
G. Belt Idler
Pivot
1 1 Yearly
H. Front Caster
Hubs
*0 2
Yearly
Fig. 001 g. 13a G020222
3. Lubricate front caster pivots once a year. Remove
hex plug and cap. Thread grease tting in hole
and pump with grease until it oozes out around top
bearing. Remove grease tting and thread plug back
in. Place cap back on.
* Seestep3forspeciallubricationinstructionsonthefront
casterpivots.
A B
G
H
C
F
D
E