CHASSIS
3-19
Toro 30” Aerator Service Manual
3
3. Slide the axle assembly inward (it will be necessary
to cock the unit at an angle to get the rear tine stub
shaft hooked behind the sprocket). As you rotate the
tines clockwise to install the unit (Fig. 061).
5. Install the four screws securing the axle assembly
back in position, install the four nuts and tighten
securely (Fig 063).
Fig. 061 IMG-1059
4. Reinstall the chain onto the sprocket and replace the
two tines that were previously removed (Fig. 062).
Fig. 062 IMG-1056a
Fig. 063 IMG-1048
6. Slide the chain tensioner onto the top of the chain
and re-tighten with very little play in the chain. (Fig
064).
Fig. 064 IMG-1052a
To Next Page
Loading...
