Toro 23518 - Electrical and Hydraulic Diagrams

HYDRAULICS & ENGINE MOUNTING
4-5
Toro 30” Aerator Service Manual
4
4. Check the hydraulic reservoir and if necessary ll the
reservoir to the appropriate level with Toro Hydro Oil
(Fig. 071).
Note: Hydraulic oil ll level to be between “COLD”
bafe and down a 1/4” below. Check with the
aerator tines down (resting on the ground)
and uid temperature at 71
o
+ 10
o
F (21.6 +
6.6
o
C).
Fig. 071 hyd reservoir tank
5. Replace the hydraulic reservoir cap and tighten until
snug. DO NOT OVERTIGHTEN.
6. Install the previously removed rear pad and tighten
the bolts, securing it to the frame.