HYDRAULICS & ENGINE MOUNTING
4-17
Toro 30” Aerator Service Manual
4
Transmission Installation
1. Place transaxle on a oor jack and position it under
the frame so that the bolts line up through the slotted
mounting holes (Fig. 109).
Fig. 109 IMG-0019
2. Slowly raise the tran saxle until the bolts are almost
to the frame. Install the drive belt over the PTO
clutch (Fig. 110).
Fig. 110 belt
3. Raise the transaxle up through the mounting holes.
Install the front mounting bolts, the transmission
adjuster plates, bolts and nuts. Tighten the bolts
nger tight (Fig. 111).
Fig. 111 tightener bolt
Fig. 112 idler
4. Install the stationary idler on the RH side of the unit
(Fig. 112). Torque bolt to 30 ft-lbs. (41 Nm).
To Next Page
Loading...
