HYDRAULICS & ENGINE MOUNTING
4-39
Toro 30” Aerator Service Manual
4
3. Install the hydraulic pump belt as outlined in the
“Hydraulic Pump Belt Removal & Installation” section
of this chapter.
4. Install the transaxle as outlined in the “Transmission
Installation” section of this chapter.
5. Install the throttle and choke cables (Fig. 171).
Fig. 171 cables
6. Install the ground wires (Fig. 172).
Fig. 172 ground wires
Fig. 173 harness
8. Connect the fuel line and emissions line to the
engine (Fig. 174).
Fig. 174 lines new
7. Connect the engine wiring harness to the main
wiring harness (Fig. 173).
To Next Page
Loading...
