Toro 30410 - Setup; Installing the Seat, Seat Belt, and Manual Tube

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
Seat kit (obtain separately)
1
Seat suspension kit (obtain
separately)
1
Manual tube
1
R-clamp
2
Seat belt
1
Bolt
2
1
Lock washer
2
Install the seat, seat belt, and
manual tube.
2
No parts required
–
Grease the machine.
3
Warning Decal
1
Used only on machines outside the
U.S.A.
Operator’s Manual
1
Engine Operator’s Manual
1
Parts Catalog
1
Operator Training DVD
1
Pre-delivery Inspection Sheet
1
4
CE certicate
1
Read the manuals and watch the
DVD before operating the machine.
Use the remaining parts for the
installation of attachments.
Note: Deter mine the left and right sides of the
mac hine from the nor mal operating position.
Note: Use this c har t as a c hec klist to ensure
that all par ts necessar y for assembly ha v e been
recei v ed. Without these par ts , total setup cannot
be completed. Some par ts ma y ha v e already been
assembled at the factor y .
Step
1
Installing the Seat, Seat
Belt, and Manual Tube
Parts needed for this step:
1
Seat kit (obtain separately)
1
Seat suspension kit (obtain separately)
1
Manual tube
2
R-clamp
1
Seat belt
2
Bolt
2
Lock washer
Procedure
T he mac hine is shipped without the seat assembly .
A Premium Seat, Model No . 30622 and a Premium
Suspension, Model No . 30621, m ust be purc hased
and installed.
14