Toro 30410 - Greasing the Machine; Replacing the Warning; Decal; Reading the Manuals and Viewing the DVD

1. Mount the man ual tube to the seat suspension
with the 2 R-clamps included in loose par ts .
2. Install the seat belt to eac h side of the seat with
a bolt and loc k w asher , supplied in loose par ts .
Important: Mak e sur e that the seat
s witch wir e is connected to the seat s witch
connector on the har ness.
3. Slide the seat completely forw ard and bac kw ard
to ensure proper operation and that seat switc h
wires and connectors are not pinc hed or do no
contact any mo ving par ts .
Step
2
Greasing the Machine
No Parts Required
Procedure
Before the mac hine is operated, it m ust be g reased
to ensure proper lubricating c haracteristics; refer
to Greasing the Bearings and Bushings procedure
of Lubrication , pag e 34 . F ailure to properly g rease
the mac hine will result in premature failure of
critical par ts .
Step
3
Replacing the Warning
Decal
Parts needed for this step:
1
Warning Decal
Procedure
1. On mac hines used outside of the U .S .A.,
re place the w ar ning decal, par t no . 112–9118
with the w ar ning decal par t no . 106–6752.
Step
4
Reading the Manuals and
Viewing the DVD
Parts needed for this step:
1
Operator’s Manual
1
Engine Operator’s Manual
1
Parts Catalog
1
Operator Training DVD
1
Pre-delivery Inspection Sheet
1
CE certicate
Procedure
1. R ead the man uals .
2. View the Operator T raining D VD .
15