Glow Plug Indicator Light
W hen lit, the glo w plug indicator light ( Figure 2 )
indicates that the glo w plugs are on.
Engine Temperature Gauge
T his g aug e ( Figure 2 ) indicates the engine coolant
temperature .
Speed Limiter
Adjust the screw ( Figure 3 ) to limit the amount
the traction pedal can be de pressed in the forw ard
direction to limit speed.
Important: T he traction pedal must contact
the speed limiter bef or e r eaching the end of
the pump str ok e to pr ev ent pump dama ge.
Figure 3
1. Speed limiter
Lift Levers
T he lev ers ( Figure 4 ) raise and lo w er the cutting
units .
Cutting Unit Service Lock
T he cutting unit ser vice loc k ( Figure 4 ) loc ks the
front cutting unit lift lev er when the cutting unit
is in the raised position.
Key Switch
T he k ey switc h ( Figure 4 ) has three positions: Off ,
On/Preheat, and Star t.
PTO Switch
T he PTO switc h ( Figure 4 ) has three positions: On
(eng ag e), Neutral, and Off (diseng ag e). Carefully
lift and push the PTO switc h forw ard to the On
position to star t the implement or cutting unit
blades . Slo wly pull the switc h bac kw ard to the Off
position to stop implement operation.
Hi-Lo Speed Control
T he control ( Figure 4 ) allo ws the speed rang e to
increase for transpor t of the mac hine .
Flow Divider Switch
Press and hold flo w di vider switc h ( Figure 4 )
to enhance traction dri v e perfor mance in
compromised operating conditions .
Figure 4
1. Lift lever 8. Alarm silence switch
2. Front cutting unit service
lock
9. Temperature reset switch
3. Key switch
10. Hour meter
4. PTO switch 11. Fuel gauge
5. Hi-lo speed control 12. Throttle
6. Flow divider switch 13. Audible alarm
7. Cruise control (optional)
14. Power point
Cruise Control (Optional)
T he cr uise control ( Figure 4 ) sets the speed of the
mac hine .
Fuel Gauge
T he fuel g aug e ( Figure 4 ) indicates the lev el of fuel
in the tank.
Hour Meter
T he hour meter ( Figure 4 ) sho ws the total hours
that the mac hine has been operated.
17
To Next Page
Loading...
