Toro 30410 - Premaintenance Procedures; Service Interval Chart; Lubrication; Greasing the Bearings and Bushings

If y ou lea v e the k ey in the ignition s witch, someone could accidentl y star t the engine and
seriousl y injur e y ou or other bystander s.
R emo v e the k ey fr om the ignition bef or e y ou do an y maintenance.
Premaintenance
Procedures
Service Interval Chart
Figure 32
Lubrication
Greasing the Bearings and
Bushings
T he mac hine has g rease fittings that m ust be
lubricated regularly with No . 2 General Pur pose
Lithium Base Grease . If the mac hine is operated
under nor mal conditions , lubricate all bearings
and bushings after ev er y 50 hours of operation or
immediately after ev er y w ashing .
T he g rease fitting locations and quantities are:
Traction Unit
• Brak e shaft pi v ot bearings (5) ( Figure 33 )
• T raction pedal pi v ot bushing (1) ( Figure 34 )
• F ront and rear axle pi v ot bushings (2)
( Figure 35 )
• Steering cylinder ball joints (2) ( Figure 36 )
• Tie rod ball joints (2) ( Figure 36 )
• King pin bushings (2) ( Figure 36 ).
T he top fitting on the king pin should onl y
be lubricated ann uall y (2 pumps).
34