3. W hen all of the oil has drained, position the
wheel so that the plug hole is at the ten or tw o
o’cloc k position.
4. Place a drain pan under the brak e housing on
the other side of the wheel ( Figure 59 ).
5. R emo v e the plug from the bottom of the
housing and allo w the oil to drain.
6. W hen all of the oil has drained, install the plug
in the housing .
7. Add appro ximately 16 oz (0.5 l) of high quality
SAE 85W -140 g ear lube to the planetar y fill
hole (at the ten or tw o o’cloc k position) until
the lev el is up to the bottom of the brak e
housing c hec k hole . Install the plug .
8. R e peat the procedure on the opposite g ear
assembly .
Figure 59
1. Brake housing 3. Check plug
2. Drain plug
Changing the Rear Axle
Lubricant
Chang e the oil initially after the first 200 hours
of operation and ev er y 800 hours of operation
thereafter .
1. P osition the mac hine on a lev el surface .
2. Clean the area around the 3 drain plugs; 1 on
eac h end and 1 in the center ( Figure 60 ).
3. R emo v e the c hec k plugs to ease in draining of
the oil.
4. R emo v e the drain plugs and allo w the oil to
drain into the pans .
Figure 60
1. Drain plug location
5. Clean the area around the drain plug on the
bottom of the g ear bo x ( Figure 61 ).
6. R emo v e the drain plug from the g ear bo x and
allo w the oil to drain into a pan. R emo v e the
fill plug to ease in draining of the oil.
Figure 61
1. Drain plug
7. Add enough oil to bring the lev el up to
the bottom of the c hec k plug holes; refer
to Chec king the R ear Axle Lubricant, and
Chec king the R ear Axle Gear Bo x Lubricant.
8. Install the plugs .
Checking the Rear Wheel
Toe-In
After ev er y 800 operating hours or ann ually , c hec k
the rear wheel toe-in.
44
To Next Page
Loading...
