Groundsmaster 4100--D/4110--D Cutting DeckPage 8 -- 3
General Information
CAUTION
Never install or work on the cutting deck or lift
arms with the e ngine running. Always stop en-
gine and remove ignition key first.
Operator’s Manual
The Operator’s Manual provides information regarding
the operation, general maintenance, adjustments and
maintenance intervals for your Groundsmaster cutting
deck.Refer to that publicationforadditionalinformation
when servicing the machine.
Castor Wheel Tire Pressure
Castor tires on the cutting deck should be inflated to 50
PSI (345 kPa).
Blade Stopping Time
The blades of the cutting deck should come to a com-
plete stop in approximately five (5) seconds after the
PTO switch is pushed in (disengaged).
NOTE: Makesurethedeckisloweredontoacleansec-
tion of turf or hard surface to avoid dust and debris.
To verify blade stopping stopping time, have a second
personstandbackfromthedeckatleasttwenty(20)feet
and watch one of the cutting deck blades. H ave the op-
erator push the PTO switch in to disengage the cutting
deck and record the time it takes for the blades to come
toacompletestop.Ifthisstoppingtimeisexcessive,the
braking valve(s) (RV2) on the hydraulic deck control
manifold(s) may need adjustment.
Cutting
Deck
To Next Page
Loading...
Need help?
General
