Toro 30630 Groundsmaster 328-D - Page 16

16
2. Mount seat pivot bracket to frame with 2 flange screws
supplied in kit (Fig. 5)
1
Figure 5
1. Seat pivot bracket
3. Mount seat and seat support to seat pivot bracket with
pivot shaft and roll pin (Fig. 6).
1
2
Figure 6
1. Pivot shaft 2. Roll pin
4. Hold seat up with seat support rod (Fig. 7).
5. Plug wire harness connector into seat switch connector
on bottom of seat.
1
Figure 7
1. Seat support rod
Seat Kit, Model No. 30625, Deluxe Seat
with Model No. 30628 Seat Adapter Kit
1. Mount seat suspension assembly to 4 capscrews on seat
bottom and secure with 4 lock washers, flat washers,
and nuts (Fig. 8).
2. Loosely secure 2 R-clamps to right side of seat bottom
with 2 capscrews and flat washers supplied in kit
(Fig. 8). Install manual tube into R-clamps and tighten
capscrews (Fig. 8).
3. Mount seat support over four threaded studs at the
bottom of seat suspension assembly and secure in place
with flangenuts (Fig. 8).
1
6
4
2
5
3
Figure 8
1. Seat suspension
assembly
2. R-clamps
3. Lock washer, flat washer,
and nut
4. Manual tube
5. Cap
6. Seat support
4. Mount seat pivot bracket to frame with (2) flange
screws supplied in kit (Fig. 5)
5. Mount seat and seat support to seat pivot bracket with
pivot shaft and roll pin (Fig. 6).
6. Hold seat up with seat support rod (Fig. 7).
7. Route seat switch harness through holes in seat support
and seat suspension (Fig. 9). Plug wire harness
connector into seat switch connector on bottom of seat.