18
5. Remove filler caps and slowly add electrolyte to each
cell until level is up to fill ring. Install fill caps.
Installing the Battery in the
Chassis
Battery terminals or metal tools could short
against metal machine components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
• When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the machine.
• Do not allow metal tools to short between the
battery terminals and metal parts of the
machine.
Warning
1. Install battery and secure with hold down strap and
wing nuts (Fig. 3). Remove tape over ends of each
cable.
2. Slide the red, positive battery cable (Fig. 3) onto
positive battery post and tighten nut securely.
Incorrect battery cable routing could damage the
machine and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always connect the positive (red) battery cable
before connecting the negative (black) cable.
Warning
3. Slide the black, negative battery cable (Fig. 3) onto
negative battery post and tighten nut securely.
4. Coat both battery connections with either Grafo 112X
(skin-over) grease, Toro Part No. 505-47, petroleum
jelly or light grease to prevent corrosion and slide
rubber boot over positive terminal (Fig. 3).
5. Install the instrument cover and lock the two latches.
Installing the Ball Joint and
Connecting the Lift Cylinder
Note: Ball joints are not required for all implements; refer
to implement operator’s manual for requirements.
1. Thread jam nut fully onto right-hand ball joint.
2. Screw ball joint into right hand push arm until center of
ball joint is 2-3/8 in. (60 mm) away from front of push
arm (Fig. 12). Do not tighten jam nut.
1
2
4
4
Figure 12
1. Jam nut
2. Ball joint mount
3. 2-3/8 in. (60 mm)
4. Right-hand push arm
Sudden release of the spring-loaded push arms
could cause injury.
Acquire the help of another person to help push
the arms down during installation of the ball joints
or other implements.
Warning
3. Have a helper push down on the left push arm. Then
insert a 2 x 4 in. (51 x 102 mm) block of wood between
the frame and top of the push arm (Fig. 13). Screw ball
joint into left hand push arm until center of ball joint is
2-3/8 in. (60 mm) away from front of push arm
(Fig. 13). Do not tighten jam nut.
4. Carefully remove 2 x 4 in. (51 x 102 mm) block of
wood from between frame and push arm.
5. Remove spring pin from cylinder pin and slide cylinder
pin out of cylinder.
To Next Page
Loading...
