30
Lubricating the Machine
The traction unit must be lubricated regularly. If machine is
operated under normal conditions, lubricate all bearings
and bushings after every 50 hours of operation or whenever
water is used to clean machine.
1. The traction unit bearings and bushings that must be
lubricated are: PTO shaft and yokes (Fig. 27); lift arm
pivots (Fig. 27); right and left push arm ball joints
(Fig. 27); push arm pivot bushings (Fig. 28); PTO pivot
housing blocks (Fig. 29); brake pivot bushings
(Fig. 30); rear wheel spindle bushings (Fig. 31);
steering plate bushings (Fig. 31); axle pin bushing
(Fig. 31) and engine output shaft bearing (Fig. 32). Also
apply grease to both brake cables at the drive wheel and
brake pedal ends.
(3)
Figure 27
Figure 28
Figure 29
Figure 30
Figure 31
Figure 32
To Next Page
Loading...
