6
SPECIFICATIONS
Width of Cut: 72"
Configuration: Three blades, one blade center
section, and two 1 blade floating wings. Wings flex up
and down 12 degrees in a single plane perpendicular
to from center section.
Height of Cut: Adjustable front and rear, in .50 inch
increments from 1 to 4 inches.
Construction: 12-gauge steel, 5.25 inches deep,
welded construction and reinforced with 10-gauge
steel channels.
Blades: Three 25 inch long, .250 inch thick, heat
treated steel blades.
Cutter Drive: PTO driven gearbox with 1.26-1 spiral
bevel gears. One "B" section belt on center section.
One "B" section belt on each wing. Center section
tensioned through spring loaded idler. Wings
tensioned through adjustable fixed idler.
Spindles: Cast iron housing, 1-1/4 inch dia shaft with
welded blade retainer. Turning on two greaseable
tapered roller bearings. A positive splined connection
attaches pulley to spindle shaft.
Castor Wheels: Front: Four 8 inch pneumatic wheels
with greaseable roller bearings. Rear: Two 8 inch
pneumatic wheels with greaseable roller bearings (one
on each wing). Center section suspended from push
arms.
Anti Scalp: Anti-scalp cup (11 inch diameter) located
on each blade. One anti-scalp roller on rear of center
section. Adjustable skid on right wing.
Trimability: 34" uncut circle, 25" uncut circle with use
of individual wheel brakes.
Tip Speed: 15,000 ft./min. @ 3200 engine RPM.
Discharge: Left hand, side discharge (recycler kit
available).
Safety Certification: To meet, proposed ANSI
B71.4-1990 and 1999, safety specifications for power
lawn mowers, and CE requirements.
Belt Covers: Steel covers bolted down, meets CE
requirements.
Sound Levels: 90 dba @ operator ear.
Weight: 550 lbs.
Width: 83.5 in.
Options:
High Lift Blade: Part No. 23-2410
Height of cut spacers 1/4" Part No. 54-8810
Tire - Foam Filled 8" Part No. 93-5974
Specifications and design subject to change without notice.
To Next Page
Loading...
