Toro 31050 - Page 199

g289054
Figure101
1.Oilcooler
5.Bracket
2.Nut6.Hydraulichose
3.Bolt7.Hydraulichose
4.Washer
RemovingtheOilCooler
Theradiatorandoilcoolermustberemovedfromthemachineasanassembly;
refertoRemovingtheRadiator(page4–8).
InspectingtheOilCooler
1.Backushtheoilcoolerwithcleaningsolvent.Aftercleaningthecooler,
ensurethatallthesolventisdrainedfromthecooler.
WARNING
Useaneyeprotectionsuchasgoggleswhenusingthecompressed
airtodrytheoilcooler.
2.Usethecompressedairintheoppositedirectionoftheuidowanddry
theinteriorsoftheoilcooler.
3.Installthecleanplugsontheoilcoolerports.Cleantheoutersurfaceof
thecooler.
Note:Theoilcoolermustbefreefromcorrosion,crackedtubes,orexcessive
pittingoftubes.
InstallingtheOilCooler
Theradiatorandoilcoolermustbeinstalledintothemachineasanassembly;
refertoInstallingtheRadiator(page4–10).
ProLineH800
Page5–131
HydraulicSystem:ServiceandRepairs
19241SLRevB