Toro 31051 - Page 267

RemovingtheLiftArms
1.Parkthemachineonalevelsurface,settheparkingbrake,lowerthecutting
deck,shutofftheengine,andremovethekeyfromthekeyswitch.
2.Removethecuttingdeckfromtheliftarms;refertotheOperator’sManual.
CAUTION
Whenchangingthetiresorperformingotherservice,usecorrect
jacksandsupports.Makesurethatthemachineisparkedonasolid,
levelsurfacesuchasaconcreteoor.Priortoraisingmachine,
removeanyattachmentsthatmayinterferewiththesafeandproper
raisingofthemachine.Alwayschockorblockwheels.Usejack
standstosupporttheraisedmachine.Ifthemachineisnotproperly
supportedbyjackstands,themachinemaymoveorfall,whichmay
resultinpersonalinjury.
3.Chocktherearwheelsandjackupfrontofthemachine.Supportthemachine
onjackstands;refertoJackingInstructions(page1–7).
4.Removethefrontwheelnexttotheliftarmthatistoberemoved;referto
RemovingtheWheels(page7–3).
5.Removethenut(12),washer(11)andpin(9)thatsecurestheliftcylinder
(14)totheliftarm.Separatetheliftcylinder(14)fromtheliftarm.
6.Removethenut(1),washers(2)andbolt(8)thatsecurestheliftarmtothe
frame.Removetheliftarmfromtheframe.
7.Disassembletheliftarmasnecessary(Figure150).
InstallingtheLiftArms
1.Assembletheliftarm(Figure150).
2.Positiontheliftarmtotheframeandsecuretheliftarmwiththebolt(8),
washers(2)andnut(1).
3.Aligntheliftcylinderwiththeliftarm.Slidethepin(9)throughtheliftarmand
cylinderend.Securethepinwiththewasher(11)andnut(12).
4.Installthefrontwheelnexttotheliftarmthatwasremoved;refertoInstalling
theWheels(page7–4).
5.Installthecuttingdeckontotheliftarms;refertotheOperator’sManual.
6.Lubricatetheliftarmgreasettings.
7.Afterassemblyiscompleted,raiseandlowerthecuttingdecktoverifythat
thehydraulichosesandttingsdonotcontactanything.
8.Checktheheight-of-cutandlevelingofmoverdeck;refertotheOperator’s
Manual.
ProLineH800
Page7–11
Chassis:ServiceandRepairs
19241SLRevB