Toro 414300000 - Adjusting the Height-Of-Cut; Adjusting the Anti-Scalp Rollers; Adjusting the Flow Baffle

AdjustingtheHeight-of-Cut
Theheight-of-cutcanbeadjustedfrom38to127mm
(1-1/2to5inches)in6mm(1/4inch)increments.
Note:Usingaheight-of-cutunder51mm(2inches)
increasesthewearonthemower-deckbelt.Usea
height-of-cutthatisgreaterthan51mm(2inches)
wheneverpossible.
g267253
Figure22
AdjustingtheAnti-Scalp
Rollers
Modelswitha60-InchDeckOnly
Wheneveryouchangetheheight-of-cut,adjustthe
heightoftheanti-scalprollers.
1.Disengagetheblade-controlswitch(PTO),move
themotion-controlleverstotheNEUTRAL-LOCK
position,andengagetheparkingbrake.
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Removethenutandboltpositiontheanti-scalp
rollersandinstallthenutandbolt.
4.Ensurethatthespacersandbushingsare
installed(Figure23).
g018324
Figure23
1.Bushing4.Bolt
2.Anti-scalproller5.Nut
3.Spacer
AdjustingtheFlowBafe
Youcanadjustthemower-dischargeowfordifferent
typesofmowingconditions.Positionthecamlock
andbafetoprovidethebestqualityofcut.
1.DisengagethePTO,movethemotion-control
leverstotheNEUTRAL-LOCKposition,and
engagetheparkingbrake.
2.Shutofftheengine,removethekey,andwait
forallmovingpartstostopbeforeleavingthe
operatingposition.
3.Toadjustthebafe,loosentheknob(Figure24).
4.Adjustthebafeandknobintheslottothe
desireddischargeowandtightentheknob.
21