Mid-Mount Z Service Manual 5 - 5
CHASSIS
8. To remove the brake brackets, remove the 2 bolts
at the front of the wheel motor and remove the
bracket (Figure 81).
Figure 81
1227-001
9. To remove the brake shaft, first remove the
hydraulic fluid reservoir which is held in place by 2
cap screws and nuts (Figure 82).
Figure 82
1030-006
10. Then remove the brake shaft bearing bolts at
either end of the shaft (Figure 83).
Figure 83
1030-009
11. Then lift the brake shaft out of the chassis.
12. To remove the brake lever, first remove the control
panel at the console (Figure 84).
Figure 84
1030-008
To Next Page
Loading...
