Figure 8
5. Raise the roll bar into the upright position and
secure it with the pins and hair pin cotter pins
fastened to the lanyards
Figure 9
6. T or que all lo w er fasteners , attac hed to the
mac hine frame , to 30 ft-lb (41 N ⋅ m).
7. Tighten the center roll bar bolts (1/2 x 3-1/4
inc h) so it rotates freely with some resistance .
Note: No more than one thread should be
exposed outside the n ut.
Figure 10
Step
5
Adding Fuel to the Machine
No Parts Required
Procedure
Add g asoline to the mac hine before star ting it.
R efer to y our Operator’ s Manual. for the cor rect fuel
and procedure .
4
To Next Page
Loading...
