Toro 74408 Z334 Z Master - Adjusting the Anti-Scalp Rollers; Positioning the Seat; Pushing the Machine by Hand

AdjustingtheAnti-Scalp
Rollers
Wheneveryouchangetheheight-of-cut,adjustthe
heightoftheanti-scalprollers.
1.DisengagethePTO,movethemotioncontrol
leverstotheneutrallockedpositionandsetthe
parkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Afteradjustingtheheight-of-cut,adjusttherollers
byremovingtheangenut,bushing,spacer,and
bolt(Figure17).
4.Selectaholesotheanti-scalprollerispositionedto
thenearestcorrespondingheight-of-cutdesired.
5.Installtheangenutbushing,spacer,andbolt.
Torqueto40-45ft-lb(54-61N•m)(Figure17).
6.Repeatthisadjustmentontheotheranti-scalp
rollers.
Figure17
1.Bolt4.Anti-scalproller
2.Anti-scalprollerbracket
5.Spacer
3.FlangeNut6.Bushing
PositioningtheSeat
Theseatcanmoveforwardandbackward.Positionthe
seatwhereyouhavethebestcontrolofthemachine
andaremostcomfortable.
1.Raisetheseatandloosentheadjustmentbolts
(Figure18).
2.Movetheseattothedesiredpositionandtighten
thebolts.
Figure18
1.Adjustmentbolts
2.Seat
PushingtheMachinebyHand
Important:Alwayspushthemachinebyhand.
Nevertowthemachinebecausedamagemay
occur.
ToPushtheMachine
1.Disengagethebladecontrolswitchandmovethe
controlleverstotheneutrallockedpositionand
applytheparkingbrake.
2.Stoptheengine,removethekey,andwaitforall
movingpartstostopbeforeleavingtheoperating
position.
3.Pullthetwobypassleversrearwardandpushthem
totheoutsideintotheslottolockthemintoplace.
(Figure19).
Note:Makesurebothbypassleversaredisengaged
beforepushingthemachine.
4.Disengagetheparkingbraketopushthemachine.
18