Toro 74490 - Adjusting the Motion Control Handle Position

MotionControlAssemblyInstallation(continued)
g337846
Figure53
5.Connectthemotioncontroldampertothemotioncontrolassemblyand
torquetheboltto108-135N•m(90±10in-lb).
6.Installthemotioncontrolcovertotheframe,securewiththe2screws.
7.Connectthemotioncontrolhandletothemotioncontrolassembly.
8.Adjusttheneutralsetting.
9.Lowertheunitandverifyproperfunction.
10.Adjustthetrackingifnecessary.TrackingAdjustment(page7–7)
AdjustingtheMotionControlHandlePosition
Note:Ensureproperadjustmentofneutralandtrackingsettingsbeforeadjusting
themotioncontrolhandles.TrackingAdjustment(page7–7)
1.ParkthemachineonalevelsurfaceanddisengagethePTO.Stopthe
engine,waitforallmovingpartstostop,andremovethekey.
2.Movetheleversintotheoperatingposition.
3.Loosenthe2boltsthatsecurethemotioncontrolhandlestothemotion
controlassembly.
Chassis:ServiceandRepairs
Page5–30
2000SeriesZMASTER®ServiceManual
3438-778RevA