Toro 74492 - Throttle Cable Assembly Replacement

ROPS(RollOverProtectionSystem)Removal(continued)
4.LifttheROPSassemblyoffofthemachine.
ROPS(RollOverProtectionSystem)Installation
1.LifttheROPSassemblyintopositionontherearsideofthemountingsupport.
2.Installthe4mountingbolts.
Note:OrientationoftheROPShardwareiscritical.Makesurethatthebolts
areorientated
g336054
Figure38
3.TorquetheROPSconnectinghardwareto122–135N•m(95±5ft-lb).
4.Installtherightandleftconsoles.RightConsoleReplacement(page5–13)
LeftConsoleReplacement(page5–11)
ThrottleCableAssemblyReplacement
ThrottleCableAssemblyRemoval
1.ParkthemachineonalevelsurfaceanddisengagethePTO.Stopthe
engine,waitforallmovingpartstostop,andremovethekey.Engagethe
parkingbrake.
2.Disconnectthebatterybyremovingthenegativecablerst,thenthepositive
cablefromthebattery.
3.Removethecontrolpanelassemblyfromtherightconsole.
4.Removetheknobfromthethrottlelever.
Chassis:ServiceandRepairs
Page5–20
2000SeriesZMASTER®ServiceManual
3438-778RevA