Toro 74492 - Hydraulic System Maintenance; Hydraulic Fluid Level Check; Hydraulic Fluid and Filter Change; Hydraulic-System Filter Removal

ThrottleCableAssemblyInstallation(continued)
g336057
Figure41
2.Attachthethrottlecableassemblytothecontrolpanelassemblyusing2
boltsandnuts.
3.Installtheknobonthethrottlelever.
4.Installthecontrolpanelassemblyintotheconsole.
5.Movethethrottlecontrollevertotheslowidleposition.
6.PlacetheZ-bendofthethrottlecableinthethrottleplateontheenginein
thepositionpreviouslynoted.
7.Placethecableunderthecableclamp.
8.Ensurethatthethrottlecontrolleverisintheslowidlepositionandtighten
thecableclamp.
9.Connectthebatterybyinstallingthepositivecablerst,thenthenegative
cabletothebattery.
ChokeControlAssemblyReplacement
ChokeControlAssemblyRemoval
1.ParkthemachineonalevelsurfaceanddisengagethePTO.Stopthe
engine,waitforallmovingpartstostop,andremovethekey.Engagethe
parkingbrake.
2.Disconnectthebatterybyremovingthenegativecablerst,thenthepositive
cablefromthebattery.
3.Loosentheclampsecuringthechokecabletothechokeplateontheengine
4.Removethechokecablefromtheplate,notingthepositionofthecable
intheplate.
5.Removethecontrolpanelassemblyfromtherightconsole.
6.Onthebottomsideofthecontrolpanelassembly,loosenthejamnut
securingthechokeleverinplace.Removethenutfromthechokecable.
7.Pullthechokecableassemblythroughthecontrolpanelandoutofthe
machine.
ChokeControlAssemblyInstallation
1.Routethechokecablethroughthecontrolpanelassembly.
Chassis:ServiceandRepairs
Page5–22
2000SeriesZMASTER®ServiceManual
3438-778RevA