Toro 74492 - Page 84

LevelingtheMowerDeck(continued)
6.Measurebetweentheoutsidecuttingedges(bladetips)andtheatsurface.
Ifallmeasurementsarenotwithin5mm(3/16inch),anadjustmentis
requiredandthisprocedureshouldbecontinued.
7.Rotatethebladessothattheyareperpendiculartotherearofthedeck.
Ensurethefrontbladetipislowerthantherearbladetipasindicatedinthe
BlockHeightandRakeT able(step12).
g336158
Figure67
1.BladesFronttoRear
3.MeasurefromtheTipoftheBladetothe
FlatSurface
2.BladeTip
8.Settheanti-scalprollerstothetoppositionorremovecompletelyforthis
procedure.
9.For60inchdeckonly:
•Raisethedecktothetransportposition.
•Slowlyloosentheadjustingscrewontheliftassistspringuntilthescrew
canberemoved.Savethescrewforinstallation.
10.Place2blocks(seeBlockHeightandRaketablestep12)undertherear
edgeofthecuttingdeckskirt,oneoneachsideofthecuttingdeck.
11.Settheheight-of-cutlevertothe76mm(3inch)position.
12.Place2blocksundereachsideofthefrontedgeofthedeck,butnotunder
theanti-scalprollerbracketsorwelds.
Deck:ServiceandRepairs
Page6–10
2000SeriesZMASTER®ServiceManual
3438-778RevA