Toro 74954 - Page 120

HYDRAULIC SYSTEM
5-25Toro Z Master G3 3000/5000/6000 Series Service Manual
5
10. On the side of the machine being serviced, remove
the locknut from the wheel hub (Fig. 342).
13. Hold the end of the threaded rod with a tool. With a
socket wrench, remove the lock nut and washer from
the end of the cable (Fig. 344). Remove the washer
and spring.
Fig. 342 DSCN-4516a
Fig. 344 DSCN-4315a
11. Disengage the park brake lever.
12. Remove the e-ring, washer, and brake pin from the
L-Bracket (Fig. 343).
Fig. 343 DSCN-4314a
14. Remove the e-ring from the groove in the cable end
and the cable anchor located on the transmission
(Fig. 345).
Fig. 345 DSCN-4318a