Toro CM Series - Page 17

1
2
3
4
G021 107
Figure19
RaisingtheStabilizerLegs
End-DumpModelsOnly
End-dumpmodelshaveafrontstabilizerlegand2rear
stabilizerlegs.
Raisethestabilizerlegsbeforetowingthemachine.
1.Adjustthemachinesothatthereisnoweightresting
ontherearstabilizerlegs.
2.Pulltheclevispinoutfrom1oftherearstabilizerlegs
andthebracket(Figure20).
G019917
Figure20
3.Slidethestabilizerlegupinthebracketandalignthe
pinholeofthebracketwiththelowerholeinthe
stabilizerleg(Figure20).
4.Pushtheclevispinthroughtheholeinthebracketand
thestabilizerleg(Figure20).
5.Repeatsteps1through4fortheotherrearstabilizer
leg.
6.Liftupwardonthetonguesothatthereisnoweight
restingonthefrontstabilizerleg.
7.Pulltheclevispinoutfromthefrontstabilizerlegand
thetongue(Figure21).
G019915
3
2
1
Figure21
1.Removetheclevispin.3.Installtheclevispin.
2.Rotatethestabilizerleg
up.
8.Rotatethefrontstabilizerlegupintothetongue
(Figure21).
9.Pushtheclevispinthroughtherearwardholeinthe
tongueandthefrontstabilizerleg(Figure21).
17