HYDRAULIC SYSTEM
4-20 Z580/Z593/Z595 Diesel Service Manual
4
16. Remove the 2 rear wheel motor mounting bolts,
spacers and nuts (Fig. 308).
Note: As a reminder, prior to connecting the hy-
draulic lines, the o-rings should be replaced
with new ones and lightly lubricated with
petroleum jelly.
Note: There are two different spacers used on the
wheel motors (Fig. 310). The short spacers
are used in the front of the wheel motor (with
the brake linkage) and the long spacers are
used to retain the back of the wheel motor.
Fig 308 PICT-3377
Fig 310 CLR DSC-2117
17. Remove the wheel motor (Fig. 309).
18. For wheel motor service, refer to Parker/Ross Wheel
Motor Service Manual (form no. 492-4753).
A. Short spacer B. Long spacer
Fig 309 PICT-3378
Wheel Motor Installation
AB
To Next Page
Loading...
