MOWER DECKS
7-16 Z580/Z593/Z595 Diesel Service Manual
7
17. Turn the spindle housing over and install the lower
bearing race into the spindle housing (Fig. 745).
Note: The wider inside diameter of the bearing race
should be facing up to accept the tapered
bearing.
Fig 745 CLR DSC-2690
18. Pack the tapered bearing with #2 grease and install
the tapered bearing (Fig. 746).
Fig 746 CLR DSC-2691
15. Install the spacer through the top of the spindle
housing (Fig. 743).
Fig 743 CLR DSC-2688
16. Using a press, install the upper bearing race into the
spindle housing (Fig. 744).
Note: The wider inside diameter of the bearing race
should be facing up to accept the tapered
bearing.
Fig 744 CLR DSC-2689
To Next Page
Loading...
