Toro Diesel Z Master - Page 241

MOWER DECKS
7-18 Z580/Z593/Z595 Diesel Service Manual
7
24. Install the bearing shield and the seal spacer onto
the spindle shaft (Fig. 752).
26. Install the seal spacer on the top of the spindle
housing (Fig. 754).
Fig 752 CLR DSC-2702
Fig 754 CLR DSC-2704
25. Lower the spindle housing over the spindle shaft
(Fig. 753).
Fig 753 CLR DSC-2703
23. Install the seal. Press it fl ush with the top of the
housing (Fig. 751).
Note: The open lip of the seal faces inward.
Fig 751 CLR DSC-2696