MOWER DECKS
7-80 Z580/Z593/Z595 Diesel Service Manual
7
57. Check the cross shaft end play measurement,
it should be between .004” and .012” (.101 and
.305mm). Adjust the open end cap shims to adjust
backlash (Fig. 983).
59. Install a new o-ring on onto the pinion housing (Fig.
985).
Fig 983 IMG-8564
Fig 985 IMG-8569
60. Insert the pinion shaft assembly into the gearbox
assembly seating the pinion gear into the cross shaft
gear (Fig. 986).
58. Install .013” (.33mm) thickness of shims onto the
pinion housing (Fig. 984).
Note: The shim color corresponds to its thickness:
Blue: .005” (.127mm) thick
Green: .003” (.076mm) thick
Brown: .010” (.254mm) thick
Fig 986 IMG-8570a
Fig 984 IMG-8567
To Next Page
Loading...
