CHASSIS
3-38 Z580/Z593/Z595 Diesel Service Manual
3
5. Ensure the brake cross shaft rotates freely in the
fl ange bearings.
6. Install the clevis spring pin securing the brake rod
linkage yoke to the right side of the brake cross shaft
(Fig. 145).
Fig 145 PICT-2956
7. Install the clevis spring pins securing the brake rod
linkage yoke to the left side of the brake cross shaft
(Fig. 146).
Fig 146 PICT-2954
3. Position the fl ange bearing on the right end of the
cross shaft and install 2 bolts and nuts securing the
fl ange bearing to the frame (Fig. 143).
Fig 143 PICT-2958a
4. Position the fl ange bearing up to the left side of
the frame and install 2 bolts and nuts to secure the
fl ange bearing to the frame (Fig. 144).
Fig 144 PICT-2960
To Next Page
Loading...
