Toro Diesel Z Master - Motion Control Assembly Installation; Left Hand Motion Control

CHASSIS
3-53Z580/Z593/Z595 Diesel Service Manual
3
2. Position the left hand motion control assembly and
control shaft arm assembly into the traction frame
(Fig. 201).
Fig 201 PICT-3134
3. Install 2 bolts and nuts securing the side fl ange
bearing to the inside of the traction frame (Fig. 202).
Fig 202 PICT-3128
Motion Control Assembly Installation
28. Inspect the side fl ange bearings. Replace if worn or
damaged (Fig. 199).
Fig 199 PICT-3137a
1. Slide a side fl ange bearing onto each end of the left
hand motion control assembly (Fig. 200).
A. Side fl ange bearing (2)
B. Left hand motion control assembly
C. Neutral switch (reverse side of motion control
assembly)
D. Control shaft arm
Fig 200 PICT-3138a
A
A
A
A
D
D
C
C
B
B
Left Hand Motion Control