Toro GrandStand Series - Page 106

CHASSIS
3-85Toro GrandStand Service Manual
3
57. 2009 only: Serial range 290000210 - 290999999:
Push down on the control fork assembly and remove
the center roller from the pump control arm slot (Fig.
0318).
Fig. 0318 IMG-9436a
58. 2009 only: Repeat steps 54 through 57 on the LH
side.
59. 2010 only: Remove the shifter links and the 3 rol-
lers located on the rear end of the shifter links inside
of the control fork assemblies (Fig. 0319).
Fig. 0319 IMG-0936a
Shifter Link and Roller Congurations (Fig. 0320):
A. 2009: Serial range 290000001-290000210;
3 rollers, all thin and same size
B. 2009: Serial range 290000211-290999999;
3 rollers, large center roller
C. 2010: Serial range 310000001-310999999;
3 rollers, all large and same size
Fig. 0320 IMG-0941a
A
B
C
60. Unhook the “J” hook end of the torsion spring from
the shifter plate (Fig. 0321).
Fig. 0321 DSCN-1039a