CHASSIS
3-87Toro GrandStand Service Manual
3
66. Remove the deck belt from the clutch pulley (Fig.
0326).
Fig. 0326 DSCN-1053a
67. Using a spring tool, remove the hydro drive idler
spring from the spring anchor (Fig. 0327).
Note: On 2009 machines the extension spring
hooks to the rear of the engine base.
Fig. 0327 DSCN-1059a
68. Remove the drive belt.
69. Remove the two set screws securing the pump
pulley to the pump input shaft (Fig. 0328).
Fig. 0328 DSCN-1066a
70. Remove the pump pulley.
71. Remove the key from the key slot in the pump input
shaft (Fig. 0329).
Fig. 0329 DSCN-1074a
To Next Page
Loading...
