CHASSIS
3-96 Toro GrandStand Service Manual
3
14. Loosely install the bolt and nut securing the engine
plate front mounting tab to the top of the mower deck
(Fig. 0362).
16. Repeat step 15 on the other side of the engine plate.
17. Tighten all ve sets of nuts and bolts securing the
engine base to the mower deck.
18. Remove the hoist from the engine assembly.
19. Place the idler pivot bolt down through the engine
base (Fig. 0364).
Fig. 0362 DSCN-1169a
15. Loosely install the two sets of bolts and nuts secur-
ing the rear of the engine base to the rear of the
mower deck (Fig. 0363).
Fig. 0363 DSCN-1112a
Fig. 0364 DSCN-1170a
20. Place the large spacer, one friction composite
washer and bushing onto the pivot bolt (Fig. 0365).
Fig. 0365 DSCN-1178a
To Next Page
Loading...
