CHASSIS
3-98 Toro GrandStand Service Manual
3
25. Secure the pump to the engine base using two car-
riage bolts, washers and nuts (Fig. 0370).
28. Position the pulley on the pump shaft and secure
with the two set screws (Fig. 0372).
Note: The face of the pulley hub should be ush
with the end of the pump shaft.
Fig. 0370 DSCN-1194a
26. Repeat step 25 on the other pump.
27. Install the square key in the pump input shaft and
apply anti-seize around the shaft (Fig. 0371).
Fig. 0371 DSCN-1198a
Fig. 0372 DSCN-1199a
To Next Page
Loading...
