CHASSIS
3-101Toro GrandStand Service Manual
3
Note: The speed control cable must route up the
front side of the drive linkage mount assem-
bly (Fig. 0380).
Fig. 0380 DSCN-1215a
34. Route the speed control cable along the left side of
the LH pump (Fig. 0379).
Fig. 0379 DSCN-1214a
35. Secure the shifter and speed control cable assembly
to the engine base using two thread forming screws
and washers (Fig. 0381).
Fig. 0381 DSCN-1218a
36. Hook the “J” hook end of the torsion spring on the
lower shifter plate (Fig. 0382).
Fig. 0382 DSCN-1221a
To Next Page
Loading...
