Toro GrandStand Series - Page 124

CHASSIS
3-103Toro GrandStand Service Manual
3
40. 2009 only: Serial range 290000210 - 290999999:
Slide the right hand roller onto the rear end of the
right hand shifter link rod. Slide the rear end of the
shifter link rod (with roller) through the control fork
assembly following the Allen wrench through to
capture the center roller on the shifter link rod (Fig.
0387).
Fig. 0387 IMG-9432a
41. 2009 only: Serial range 290000210 and up: Slide
the left hand roller onto the rear end of the right hand
shifter link rod and into the outside of the control fork
assembly (Fig. 0388).
Fig. 0388 IMG-9430a
42. 2009 only: Secure the front end of the RH shifter
link to the shifter bracket using a hairpin cotter and
washer (Fig. 0389).
Fig. 0389 IMG-0348a
43. 2009 only: Repeat steps 37 through 42 on the LH
side.
44. 2010 only: Slide 3 rollers onto the rear end of the
shifter links. Slide the rear end of the shifter links
(with three rollers) into the control fork assemblies
(Fig. 0390).
Fig. 0390 IMG-0948a