Toro GrandStand Series - Page 173

CHASSIS
3-152 Toro GrandStand Service Manual
3
41. Loosely install the four sets of bolts, spacers, and
nuts (two sets per side) that secure the axle and
wheel assembly to the carrier frame using (Fig.
0573).
Fig. 0573 DSCN-1386a
Note: The bolts are installed downwards though the
carrier frame, then down through the wheel
motor mounts (Fig. 0574).
Fig. 0574 DSCN-1389a
42. Tighten all four sets of fasteners.
43. 2009 only: Install the spacer into the rear cross
shaft hub (Fig. 0575).
Fig. 0575 DSCN-1603a
44. 2009 only: Install the bolt through the carrier frame,
then through the spacer and hub assembly (Fig.
0576).
Fig. 0576 DSCN-1606a