Toro GrandStand Series - Page 175

CHASSIS
3-154 Toro GrandStand Service Manual
3
49. 2010 only: Repeat steps 47 and 48 on the LH side
of the machine.
50. Install the “Z” bend of the speed control cable to the
speed control handle assembly (Fig. 0581).
Fig. 0581 DSCN-1015a
51. Secure the speed control cable to the speed control
handle assembly with the clip on the end of the
cable jacket (Fig. 0582).
Fig. 0582 DSCN-1482a
52. Install the motion control cable adjustment nuts into
the linkage mount (Fig. 0583).
Fig. 0583 DSCN-1409a
53. Secure the motion control cables to the linkage
mount using the spring clip (Fig. 0584).
Fig. 0584 DSCN-1410a