Toro GrandStand Series - Page 19

SPECIFICATIONS
2-8 Toro GrandStand Service Manual
2
Domestic GrandStand Specications cont.
Mower Engagement: Engine Mounted Electric Clutch
Clutch Adjustment: Periodic Air Gap Adjustment Required - .018” + .003” (0.45 + 0.0762 mm)
PTO Drive Belt: HB Section w/Aramid (Kevlar) Cords and Dry Clutching Envelope
PTO Idler: Spring Loaded Pivot Hub w/Friction Washer Dampening
Deck Drive Belt: HA Section with Aramid (Kevlar) Cords and Standard (Non-Clutching) Envelope
Deck Drive Idler: Spring Loaded Pivot Hub w/Friction Washer Dampening
Mower Decks:
HOC Range: 1” to 5” in 1/4” increments (25.4mm to 127mm in 6.3mm increments)
Blades: Three .250” (6.3mm) Thick Heat Treated Steel Blades
Spindles: Machined Steel 1.00” (25mm) Diameter Shaft
Spindle Housing: Ductile Cast Iron, 9-3/8” (24cm) Diameter Mounted with Six Bolts
Bearings: Greasable Ball Bearings with Grease Fitting for Lubrication
Construction: 7 gauge (.179” / 4.5mm) Steel Welded Construction
Blade Tip Speed: (Domestic) 48” - 18,750 ft/m calculated @ 3600 engine RPM
52” - 18,750 ft/m calculated @ 3600 engine RPM
60” - 18,750 ft/m calculated @ 3600 engine RPM
Skid Plate: Standard
Adjustable Discharge Bafe: Standard
Rubber Discharge Chute: Standard
Unit Dimensions:
Deck
Width
Height
Width
Deector
Down
Width
Deector
Raised
Length
Platform
Down
Length
Platform Up
Weight*
48” (122cm) 48” (122cm) 63.5” (161cm) 49.5” (126cm) 74” (188cm) 53” (135cm) 887 lbs (400kg)
52” (132cm) 48” (122cm) 67.5” (171cm) 53.5” (135cm) 74” (188cm) 53” (135cm) 900 lbs (408kg)
60” (152cm) 48” (122cm) 75.5” (191cm) 61.5” (156cm) 74” (188cm) 53” (135cm) 925 lbs (419kg)
* Estimated operating weight