Toro GrandStand Series - Page 199

CONTROLS
4-12 Toro GrandStand Service Manual
4
5. 2010 Only: Remove the bolt, nut, washers and
spacer securing the front end of the RH shifter link
to the shifter bracket (Fig. 0672).
7. 2009 Only: Serial range 290000001 - 290000209:
Remove the right hand shifter link rod and the 3
rollers located on the rear end of the shifter link rod
from the inside of the control fork assembly and
pump control arm (Fig. 0674).
Fig. 0672 IMG-0905a
6. Remove the hairpin cotter and washer from the rear
end of the shifter link (Fig. 0673).
Fig. 0673 IMG-9424a
Fig. 0674 IMG-9486a
8. 2009 Only: Serial range 290000210 - 290999999:
There are 3 rollers located on the rear end of the RH
shifter link rod inside the control fork assembly and
pump control arm. Slide the left hand roller off the
rear end of the RH shifter link rod (Fig. 0675).
Fig. 0675 IMG-9430a