Toro GrandStand Series - Page 200

CONTROLS
4-13Toro GrandStand Service Manual
4
9. 2009 Only: Serial range 290000210 - 290999999:
Remove the rear end of the RH shifter link and the
right hand roller (Fig. 0676).
11. 2010 Only: Remove the RH shifter link and the
3 rollers located on the rear end of the shifter link
inside of the control fork assembly (Fig. 0678).
Fig. 0676 IMG-9432a
10. 2009 Only: Serial range 290000210 - 290999999:
Push down on the control fork assembly and remove
the center roller from the pump control arm slot (Fig.
0677).
Fig. 0677 IMG-9436a
Fig. 0678 IMG-0936a
Shifter Link and Roller Congurations (Fig. 0679):
A. 2009: Serial range 290000001-290000210;
3 rollers, all thin and same size
B. 2009: Serial range 290000211-290999999;
3 rollers, large center roller
C. 2010: Serial range 310000001-310999999;
3 rollers, all large and same size
Fig. 0679 IMG-0941a
A
B
C