CONTROLS
4-18 Toro GrandStand Service Manual
4
12. 2010 Only: Slide 3 rollers onto the rear end of the
RH shifter link. Slide the rear end of the shifter link
(with three rollers) into the control fork assembly
(Fig. 0696).
15. Insert a 7/32
nd
Allen wrench into the slots of the
control fork and control arm in front of the speed
control linkage rollers (Fig. 0699).
14. 2010 Only: Secure the shifter link to the shifter
bracket with a bolt two washers and nut (Fig. 0698).
Fig. 0696 IMG-0948a
13. 2010 Only: Place a spacer into the front end of the
shifter link (Fig. 0697).
Fig. 0697 IMG-0946a
Fig. 0698 IMG-0905a
Fig. 0699 IMG-1032a
To Next Page
Loading...
