CONTROLS
4-19Toro GrandStand Service Manual
4
16. While pulling the control fork assembly rearward
(not so hard that the speed control linkage moves)
tighten the screw that goes through the center of the
shoulder hub (Fig. 0700).
17. Install the washer and hairpin cotter to the end of the
speed control linkage (Fig. 0702).
Fig. 0700 IMG-1013a
Note: It is important to keep the pump control arm
and control fork slots aligned with each other.
This can be achieved by making sure the top
of the pump control arm and control fork are
parallel to each other (Fig. 0701).
Fig. 0701 DSC-0527a
Fig. 0702 IMG-9424a
18. Position the motion control cable adjustment nut into
the slot on the linkage mount and secure the speed
control cable to the motion control cable with a cable
tie (Fig. 0703).
Fig. 0703 IMG-1011a
To Next Page
Loading...
