Toro GrandStand Series - Page 207

CONTROLS
4-20 Toro GrandStand Service Manual
4
LH Control Linkage Replacement
LH Control Linkage Removal
19. Secure the cable to the linkage mount with the
spring clip (Fig. 0704).
1. Remove the bolt, nut & spacer securing the lower
end of the control cable to the LH control fork
assembly (Fig. 0706).
Fig. 0704 IMG-1022a
20. Secure the end of the control cable to the control
fork using the bolt, nut and spacer (Fig. 0705).
Fig. 0705 IMG-1008a
Fig. 0706 IMG-1033a
2. Remove the spring clip securing the motion control
cable to the linkage mount (Fig. 0707).
Fig. 0707 IMG-1009a