CONTROLS
4-22 Toro GrandStand Service Manual
4
7. 2009 Only: Serial range 290000001 - 290000209:
Remove the LH shifter link rod and the 3 rollers
located on the rear end of the shifter link rod from
the inside of the control fork assembly and pump
control arm (Fig. 0712).
9. 2009 Only: Serial range 290000210 - 290999999:
Remove the rear end of the LH shifter link and the
right hand roller (Fig. 0714).
Fig. 0712 IMG-9373a
8. 2009 Only: Serial range 290000210 - 290999999:
There are 3 rollers located on the rear end of the LH
shifter link rod inside the control fork assembly and
pump control arm. Slide the left hand roller off the
rear end of the LH shifter link rod (Fig. 0713).
Fig. 0713 IMG-9365a
Fig. 0714 IMG-9367a
10. 2009 Only: Serial range 290000210 - 290999999:
Push down on the control fork assembly and remove
the center roller from the pump control arm slot (Fig.
0715).
Fig. 0715 IMG-9371a
To Next Page
Loading...
