Toro GrandStand Series - Page 235

CONTROLS
4-48 Toro GrandStand Service Manual
4
5. Install the choke cable “Z” bend into the engine
choke lever (Fig. 0811).
Fig. 0811 IMG-1129a
4. Feed the choke cable through the ”R” clamp located
on the front, lower corner of the control tower (Fig.
0810).
3. Feed the cable through the frame, to the left of the
brake linkage (Fig. 0809).
Fig. 0809 IMG-1142a
Fig. 0810 IMG-1143a
6. Position the choke cable to the engine throttle plate
and loosely install the screw and cable clamp (Fig.
0812).
Fig. 0812 IMG-1127a